28 Sep

Goldwing – headlight info

Adjusting

gl1800riders 1

headlightadjust-goldwing

Setting position

Proper headlamp aim is achieved by adjusting the LOW AND HIGH beams.

Bike needs to be on a level floor, standing upright, loaded as you normally ride. (re, 1up-you for most), with pre-load set as you ride 1up, placed 25′ from a wall to the headlamp lens in front of the LOW beam.

I would suggest the auto adjust dial be set in the middle position for this aiming.

Measure the distance from the floor up to the center of the LOW beam bulbs. Mark this height on the wall and draw a horizontal line at this height.

Sight a point on the wall that is on the centerline of the bike. Draw a vertical line on the wall placed on this center line.

turn on the LOW beams.

Cover one of the headlamps.

Use the manual adjusters accessed from under the fairing.

Adjust the vertical until the CUTOFF LINE of the LOW beam bulb is just (VERY SMALL AMOUNT) under the horizontal line on the wall.

Adjust the horizontal until the HIGH beam hot spot is RIGHT IN THE MIDDLE of the vertical line on the wall.
Cover the headlamp just completed, and repeat procedure on the other headlamp.

Make a small mark on the auto adjust panel so you can return to the 1up setting.

Now have both headlamps uncovered and have the usual passenger you carry sit on the bike w/you, set the preload for 2up, and dial in the auto adjust dial for proper aim and mark that position on the panel by the dial.

You can repeat this for loaded 1up, loaded 2up, trailer, etc.

You get what you get for high beam aim depending on how good the headlamp design was to start with!

motor/servo feedback loop

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.